Alpha drivers where provided at time of testing and I found Windows 7 and 8.1 to have no problem but Windows 10 on a Surface Pro was currently incompatible. This could have been caused by a driver error between built in tablet computer and display. Final drivers may resolve this. (EDITOR'S NOTE: The Monoprice driver is likely incompatible with the Surface Pro's wintab driver.)
22-inch HD Multi-touch Pen Interactive Display ($760): Compatible with Windows 8.1 and Mac operating systems, the 22-inch display combines a pressure-sensitive pen with cutting-edge multi-touch capabilities to create the ultimate viewing experience for those in the design industry. The pen provides creative control with more than 2,048 levels of pressure, while the display boasts a 1920x1080p full HD resolution. Additional product highlights include:
Installing Mac Driver For Monoprice 22-inch 1080p Tablet
A couple of months ago, Twitter follower @Drewvis let me know that Monoprice had posted new device drivers on its site. He also mentioned that attaching the pen display via DVI (rather than VGA) had yielded dramatically better viewing angles. Drewvis recently published his own review of the tablet monitor which you can find here: -review-monoprice-19-interactive-pen-display.
SETTING UP THE PEN DRIVERSI still am unhappy with the Windows drivers Monoprice has posted on its site (the most recent are dated April 29), so as I did the first time around, I checked whether Huion Tablet had published more recent drivers for its compatible GT-190 tablet monitor. Coincidentally, Huion just posted a new set on June 20 here:
I experienced this and tried to recalibrate my settings. Had no idea it was the other drivers and took me about 30 minutes searching online to find the solution. So before you do anything be sure to uninstall any old tablet drivers from your computer.
This way you can set the Monoprice tablet to extend or duplicate the primary monitor. It may be a good idea to do this before installing the drivers, because if you do it afterwards it can throw off the calibration.
Precision is very accurate once you get the drivers working. Calibration seems rather basic with only four points for each corner. I was wary after first installing the software but the pressure sensitivity worked a lot better than I expected.
1) If the cursor cannot move and follow the digital pen on the working area of tablet and no tablet icon displays on the lower right corner of system tray, that outcome means the driver of installation failed. Please check the following steps:
5) If you continue to have issues with the tablet functioning on a windows pc try installing the drivers in safe mode. Restart the computer and press the F8 key as the computer starts to boot. Select Safe Mode and retry the installation again for the drivers.
I had a bit of a nightmare trying to get the drivers working with my PC. UC logic provide the drivers and there are currently two to choose from: The older 5.2f and the newer 8.1. I had been using a Monoprice tablet which go by the same drivers (5.2f) so I just plugged the new tablet in and I was away, but without hotkeys.
Mac users: You can expect similar options though not quite as extensive. I tried out the tablet with my Macbook Pro Retina and was up and running in less than a minute. Uninstalled the Wacom drivers, installed the UC Logic drivers, rebooted, plugged in and I was away.
However, the USB is useful for both power and data transmission, helping to avoid complicated wiring setups. The D13 features 7 express hotkeys, and a battery-free stylus, which is the best type of stylus for most modern tablets. The additional pen-holder carrying case is a nice touch as well with a compact design. It also has a 1080p HD display that is bright enough for creating without straining your eyes.
This will allow you to connect two, external 4K displays without installing any additional drivers. In our testing, this worked flawlessly. It supports not only mirrored displays but can extend your display as well. 2ff7e9595c
Comments